Konvergente Plattengrenzen
ozeanische – ozeanische Lithosphäre
ozeanische – kontinentale Lithosphäre
kontinentale – kontinentale Lithosphäre
Pazifische Platte
Eurasische Platte
PhilippinischePlatte
konvergente Plattengrenze„Ozean – Ozean“
konvergente Plattengrenze„Ozean – Ozean“
Mariana trench Tonga-Kermadec region
http://www.csr.utexas.edu/grace/gallery/gravity/03_07_GRACE3.html
Gravity Recovery and Climate Experiment (GRACE)
Free Air Anomalyred: +blue: -
• the trench is characterized by a negative free air anomaly (greater than -250 mgal) – due to greater water depth and sediments in the trench
• inland from the trench, a strong positive anomaly occurs – due to subduction of the cool (high density) oceanic crust. Metamorphic phase changes as the oceanic crust descends (e.g., basalt to eclogite) also contribute to the mass excess within the subducting plate.
• note the smaller amplitude positive gravity anomaly east of the subduction zone. This is caused by upwarping of the oceanic plate as it is bent into the trench.
In both cases, the Pacific Plateis subducting to the west.
Skizze!
konvergente Plattengrenze
„Ozean – Kontinent“
Südamerikanische Platte
NazcaPlatte
konvergente Plattengrenze„Ozean – Kontinent“
Oberplatte bewegt sich aktiv über Unterplatte
Subduktion der Unterplattedominante Bewegung
Kompressive und dehnende konvergente Plattengrenzen (Unterplatte wird subduziert)
Tiefe!
Bildung von Mantelschmelzen
Magmatismus: Typischerweise Andesite (>70% plag, qtz, bio, hbl cpx; Tonalit) und Dazite (qtz reicher als Andesit; Granodiorit). Da intermediäre bis saure Zusammensetzungen vorherrschen: oft explosiver (pyroklastischer) Vulkanismus - Magmen reich an gelösten Fluiden und Gasen, sehr viskos durch den hohen Si-Gehalt.
Akkretionskeilan konvergenten Plattengrenzen
Deformation und Metamorphose in AkkretionskeilenWegen T-Struktur high-P, low-T; in Verbindung mit dem vulkanischen Bogen „paired metamorphic belt“ Starke T-Gradienten, wenn Astenosphärentiefe erreicht wird counterflow von geschützten Sedimentbereichen = extremer Auftrieb von leichten Sedimenten erlaubt Aufstieg entlang der Subduktionszone (Schlammvulkane). Innerhalb des Akkretionskeils a) sedimentäre Mischung in counterflow-Strömen und b) in Imbrikationszonen durch tektonische Deformation und Porenwasserüberdruck teilweise extrem Mischung der Gesteine = Melange. Reichlich “soft-sediment” Deformation.
What drives orogeny in the Andes?S.V. Sobolev A.Y. Babeyko2005
Andinotype Orogene
Thermomechanische Modellierung
Indo – AustralischePlatte
Eurasische Platte
konvergente Plattengrenze„Kontinent – Kontinent“
konvergente Plattengrenze„Kontinent – Kontinent“
Tethys Ophiolithe – Paläo- und Mesozoische Suturen